The prongs prevent positive wind-loads from crushing the wallboard by transferring these loads to the back of the stud. Also available: HB-200-X : features three pronged punch-outs that project from the back of the anchor.Legs fabricated to accommodate up to 6" thick insulation and/or wallboard combination (state thickness when ordering).Veneer can be reinforced with optional Welded Seismic Clip ( Seismic Clip 300C w/HB-213 ).Veneer can be reinforced with optional Seismic Hook ( HB-213 SH Seismic Veneer Anchor ).Veneer can be reinforced with optional Seismiclip® Interlock System ( HB-213 S.I.S.Stainless Steel (Type 304 or Type 316) upon request.8,613,175 Test results available upon request. For foundation work, choose an anchor bolt. The X-SEAL Anchor improves upon the DW-10-X by moving the horizontal pronged. The X-SEAL Anchor is the next generation veneer anchor from H&B. Owners, architects and masons can be confident in the performance of an 'X-SEALED' metal stud / veneer wall. From zinc-plated to yellow dichromate steel, a wedge anchor’s versatility and strength handles projects from buildout to finish. The X-SEAL® Veneer Anchor is packed with more features than any other anchor on the market.
#2522 sismic veeer anchor code
The embedded portion of the 2X-Hook is 3/16”DIA round wire, satisfying the code requirement that the mortar bed thickness (typically 3/8”) must be twice the diameter of the wire. Grainger carries the wedge anchor you need for brick and block weight-bearing construction tasks.NOTE: 2X-HOOK™ CAN BE INSTALLED WITH LEGS POINTING UP OR DOWN.Formerly called the HB-200/DA-213 or HB-200 Adjustable Veneer Anchor.For concrete, CMU or brick backup, use the HB-5213.The eyelets allow 2X-HOOK™ (pintle) insertion (1 1/4" maximum allowable eccentricity) and are sized to prevent in-and-out movement beyond allowable tolerances.The L-shaped plate section has numerous ribs for added strength and 9/32" holes for connecting screws.
These results exceed BIA recommendations and the capabilities of standard “round wire” hooks or pintles by over 100%!
The compressed leg 2X-HOOK™ has been tested and designed to withstand over 200-lbf, in tension or compression, at maximum allowed offset (ACI 530 6.2.2.5.5.4) of 1-1/4” (disengagement of the pintle from the veneer anchor). The HB-213 is an adjustable veneer anchor for metal stud and wood stud construction.
0 kommentar(er)
